It may not sound like a difficult task, but constructing hexagons and other polygons can be a frustrating and daunting task for children and adults. A sketch of a square is fairly simple to make as the corners are familiar right angles that most people have no trouble creating. Every other regular polygon from equilateral triangles to dodecagons and beyond can be a challenge without a highly developed ability to recognize and construct a variety of angles. Thankfully, there is a slick technique for constructing all sorts of regular polygons based on the fact that all regular polygons fit neatly inside of a circle.

For the uninitiated, a regular polygon is a closed figure with equal length sides and equal angles. A pentagon with three centimetre sides and 108 degree angles is a regular pentagon. Regular polygons are the figures that are most commonly used to represent each family of polygons.

To experience the most success with this method, it is recommended that you use a full circle protractor. A half circle protractor will work just fine except the procedure changes slightly. The basic procedure for the full circle protractor is to place the protractor on a piece of paper, make a bunch of dots, and join the dots. The trick is dividing the 360 degrees of the circle by the number of vertices in the regular polygon, and making dots at the resulting interval. In a hexagon, for example, there are six vertices, so divide 360 degrees by six to get sixty degrees. Starting at zero degrees, make a mark every sixty degrees around the full circle protractor; there will be dots at 0, 60, 120, 180, 240, and 300 degrees. Join the dots, and voila; you have a perfect regular hexagon. With a half circle protractor, it is necessary to establish a center point first, so when you rotate the protractor to complete the dots on the other side, it can be lined up properly with the zero point and the center point.

The really nice thing about using a 360 degree circle to construct regular polygons is that it works for all of the regular polygons that one would encounter in an elementary or primary school. This is because 360 is divisible by 24 different numbers including 3, 4, 5, 6, 8, 9, 10, and 12. To construct an equilateral triangle, for example, first divide 360 by three to get 120. Make dots at 0, 120, and 240, join the dots, and enjoy a perfectly drawn equilateral triangle. Squares are constructed by marking dots at 90 degree intervals, pentagons at 72 degree intervals, octagons at 45 degree intervals, nonagons at 40 degree intervals, decagons at 36 degree intervals, and dodecagons at 30 degree intervals. "But what about a heptagon?" you may ask. Even numbers that don't divide evenly into 360 can be approximated using this method. For example, a heptagon (seven sided polygon) can be approximated quite well using 51 degree intervals. It will be hard to tell with the naked eye that you were one or two degrees off.

One limitation of this method is that there is only one size of circle available, so all of the polygons come out quite large. With a little ingenuity, this limitation can be overcome. One simple solution is to cut out a circle of paper and place it on top of the round protractor. Any paper circle smaller than the round protractor can be used. Make the dots around the edge of the paper circle lining them up with the scale on the protractor. The paper circle becomes an intermediate protractor that can be used just as the regular protractor, but it will make a smaller polygon.

Another limitation is that your students might not be at the point where they can divide or find multiples of large numbers. In this case, you could tell your students at which numbers to make the dots, or create paper protractors with just the intervals marked on them for each polygon.

This is the quickest and most efficient method I have seen for constructing regular polygons. It takes little time to teach and little time to learn, and it makes the construction of regular polygons a simple and painless activity for students. And if you need a bit of a challenge, try the 180 sided polygon with two degree intervals. I'll bet you never guessed you could make one of those so easily!